 | | SECOTEC® Refrigeration Dryers | |
Technical specification
Series TA bis TF
Air flow rate: 0.6 to 25.0 m³/min
|
 |
The cost saving effect of the SECOTEC® system
The TB 19 dryer saves a total of € 500 per year compared with dryers which use hot gas bypass control. This cost saving is calculated as follows:
| (8760 h - 1000 h) x 0.43 kW x 0.15 €/kWh = 500 € |
The graph shows a typical compressed air consumption profile. SECOTEC dryers save energy because the refrigerant system is shut down during breaks, periods of low demand and downtime – the control system operates without preset run-on periods. The integrated thermal mass ensures that the system is ready for operation at all times.
|
 | Designed and built by KAESER
As one of the world’s foremost compressed air system providers and manufacturers, Kaeser ensures that every SECOTEC dryer provides exceptional performance. Each unit is built in accordance with the very highest quality standards at the Kaeser Gera plant and undergoes stringent quality inspection as per Kaeser’s Quality Management System.
|
 | Condensate separator
As with all KAESER products, SECOTEC dryers are designed for maximum reliability. They are equipped with a specially designed condensate separator made from corrosion-resistant stainless steel* that reliably removes condensate from the air even under fluctuating airflow conditions.
* TA 5 model uses a zinc die-cast condensate separator
|
 | Minimal pressure drop
SECOTEC dryers use flow-optimised piping and usually do not require the use of a pre-filter. Pressure losses are therefore kept to a minimum, which means that maximum system pressure can be significantly reduced. This leads to considerable savings, as each 1 bar reduction represents a 6 % decrease in power consumption and also means less air is lost through leakage.
|
|
SECOTEC 
